Elden Ring logo as seen on the presentation of June 10th 2021, been waiting a while for this one. Both versions can be printed without supports or bed adhesion supports.

To paint mine I used some gold spray paint (Arexons, Oro Diamantato)

Stay hyped fellow tarnished

*Not for commercial use, the rights of the elden ring logo belong to "From Software"

Printing:

Layer Height : 0.2 will do fine Infill : 30% is enough, for use as a necklace, it may be increased

About 5mm of height should be enough

Depending on which filament and settings are used it may be necessary to clean up some stringing