A Stand for the M5Stack Basic

Print the Parts like they are in the STL-File, NO SUPPORTS needed. If you are unsure in your Bridging-Quality - set Support for the long hole for the PowerPlug of the M5

!!! ATTENTION !!!

Use M3 Screws ---- 20 mm long ---- and take a closer look at your Printer-Calibration. The Spots ,where the Stand get screwed on to the Case from the (at Backside) must be 2mm high !!!! Also the bottom of the Case must be exact 2mm high!!! . If u ignore this fact, u will break the Window out of the M5 with your Screw.

All Dimensions are about 0,2-0,3mm more wide. With good calibrated Printer - the M5 will fit perfectly