A Simple Cable clip (my first parametric model)

Change parameters in Spreadsheet to adjust dimensions.

• Wall Thickness - Thickness of backing wall, also used for clip arms (half on each side)
• Base Width - How wide the model should be (width along the cable.)
• Cable Diameter - I had a cable with a diameter of 4.25MM and rounded up to 4.3 (perfect fit for this cable :D)
• Cable squeeze % - Size of the entrance compared to the "hole", range 0.0 - 1.0 (eg 0.9 = 90%)
• Clip spacing - Spacing between clips
• Clip amount - Amount of clips you want stacked vertically

Use some doublesided tape to stick it to your desk. Works well with the foam kind of doublesided tape.

All questions and comments are welcome :)