PRINT THIS IN PETG OR ABS (PLA may not be resistant enough to outdoor heat or sunlight)

Alight, so the NM4 wasn't made with tall folk in mind so I made a few risers for it.

I am not professionally trained in CAD which will explain some of the odd shaping done to the risers.

But hey, they work.

I even made switchable logo plates to put on top of the full-sized risers.

I also included a single sided brackets (if you want to cut down print time and don't want the center portion)

if you chose either of the full-sized brackets, they can attach the go pro mount! (be sure to attach the mount before putting the riser on the the bike!!

the screws that mount the plates and the go pro mount are 7/32 or 5.5mm (pc fan screws, because that's what I had at the time)

the screws needed to connect the riser to the bike are the same size as the original windshield screws, and the original screws can be used to mount the windshield to the riser

Again, please print this in ABS or PETG.

Also I would recommend screwing the go pro mount to the riser and also gluing it.