This headset hook is inspired by dokMixer's design, I slightly changed it as the lower half has been bended to accomodate the headphone without the risk of damaging it.

I also wanted to reduce the amount of material used, without loosing the strenght of the structure so I decided to cut out the middle section.

All edges have been beveled so there should be 0 risk of damaging the headset.

|--------------------------------------| Update 06/01/2023 Version 2: I've slightly modified the design to fix some issues taking into account few comments.

• The base part has been modified to be thicker : as it seems this part usually tend to be stressed more, as time goes by this leads to breakage
• The base curvature has also been increase to fit the above change.
• The holes circumference in the base have been widened to make more room to use a screwdriver to screw the screws. Hopefully I didn't screw it all.