This is an original design of a holder for the Scrub Daddy kitchen/bathroom sponge. It was designed to be used for hand holding as well as storage.

This is a 4 hour 30 minute print on the Prusa MINI+ (40mm nozzle, 20mm layer, 10% cubic infill). It uses about 52 grams of filament.

Dimensions: 108mm x 108mm x 27mm

NOTE: I'm not sure if all Scrub Daddy sponges on the market have the same dimensions. So before printing, check to see if your sponges will fit in this model by verifying a few dimensions (see one of the included images for dimensions).