This is a Raspberry Pi4 case, easy to make with some interesting feautures.

• It is consisted by only 2 pieces. No tools, screws or bolts needed to assembly

• The fan has being placed on the side of the board so it can cool down both sides of the Raspberry. The fan nest is designed for fan dimensions 40x40x10 mm. Use a 5V fan for best perfomance or a 12V for low noice. The fan is optional if you aren't planning to overclock the device

• It has large enough opening on the side (on the card reader area) so you can easily catch the uSD card with your fingers. Also, the air from the lower side of the Raspberry is being redirected to that opening in order to cool down the uSD card. The uSD cards become hot (especially if you use a fast A2 one) and nobody takes care of them as they focused only to cool down the CPU chip. Also a few gpio cables may come out from this opening.

• There are 2 separate tube-alike openings in the led area of the board. Both leds illumination (power and activity) can be seen from outside if the box

• Small and compact, easy to print. No supports needed

• Description in all inputs-outputs

• If you need to seal it, just drill one small hole on the upper part on each side and place a small screw that holds the top cover