Entrar

Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Buscar mais como este

Modelo 3D Mini Pixel Arch por fightingosprey no Thingiverse

Descrição

Simple 20 pixel arch. Designed to fit nicely on my Ender 3. Arch is 20 cm high and 37 cm wide. About 1 inch spacing between pixels. Each end of the arch measure 20x20x10 mm. If you make your own mounts I would recommend a little bit bigger holes than 20x20x10 mm. I made mine 20,5x20x10,5 mm.

Feel free to contact me for suggestions or if you need a special mount.

Update 24.03.21: Added a 4 part print, Mini_Arch_4parts for smaller printers. Pieces are a tight fit, but worked ok on my Ender 3 at 0.28mm layer height.

Update 18.07.21: Added mounts for wooden railing. Fits 48mm by 123mm top rail.

Thingiverse

Mini Pixel Arch

fightingosprey

56

Curtidas

0

Downloads

113

Coleções

Tags

bullet pixel Pixel pixels xlights

Licença Creative Commons - Attribution

Arquivos (20)

Mini_Arch_Left.stl 623.4 KB

Mini_Arch_Right.stl 626.4 KB

Mini_Arch_Left_standoff.stl 714.4 KB

Mini_Arch_Right_standoff.stl 669.7 KB

Mini_Arch_middle.stl 243.2 KB

Mini_Arch_middle_2.stl 125.3 KB

Mini_Arch_middle_vedge.stl 63 KB

Mini_Arch_middle_vedge_half.stl 48.9 KB

Mini_Arch_end_3.stl 103.7 KB

Mini_Arch_end_cut.stl 132.5 KB

Mini_Arch_end_vedge_half.stl 32.9 KB

Mini_Arch_end_vedge.stl 49.7 KB

Mini_Arch_4parts_4.stl 313.9 KB

Mini_Arch_4parts_3.stl 414.3 KB

Mini_Arch_4parts_1.stl 313.9 KB

Mini_Arch_4parts_2.stl 411.8 KB

Mini_Arch_end_railclip.stl 234.8 KB

Mini_Arch_middle_railclip.stl 446.6 KB

Mini_Arch_middle_disk.stl 93.1 KB

Mini_Arch_end_disk.stl 204.2 KB

Ver no Thingiverse