This camera mount is based on the original, with the size and camera position being the same, but the difference here is that I created this in my own editor (DesignSpark Mechanical) so can much more easily modify it than hacking at the original camera mount STL.

I've set the camera tilt range from 10 degrees to 50 degrees, to fit a lens with a max outer diameter of 13mm (like the Foxeer DigiSight in the photos).

I created a 2nd version where the camera is pushed forwards by 10mm to reduce props in view and push the battery forwards to better help with getting the center of mass being more centered in the craft.

Plus two other variants with the front 'wedge' dropped down by 7.7mm for my own craft to help keep the end of the battery from being bumped/smashed during landings/crashes.

Print in TPU, 0.2mm layer height, 3 perimeters, no support - I included 3 support struts into the design which have an 0.2mm gap vertically so they should snap off easily afterwards, as shown in the photos.

Around 2 hours to 2.5 hours print time.

Direct download links from my website:

Short = Same as the original in terms of size/dimensions http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_Short.stl

Short Extended = Camera pushed forwards by 10mm http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_Short_Extended.stl

Tall = 7.7mm taller 'wedge' to better protect the battery http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_Tall.stl

Tall Extended = Taller and camera pushed forwards by 10mm http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_Tall_Extended.stl

Updated 13-08-2021, short & tall versions with extended shroud round the camera so for example it can protect the RunCam Nano HD better.

Short More Protection = Same as the original in terms of size/dimensions http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_More_Protection_Short.stl

Tall More Protection = 7.7mm taller 'wedge' to better protect the battery http://www.haku.co.uk/3D/TinyTrainer_New_Camera_Mount_More_Protection_Tall.stl

You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.

Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive