This is a 2 part phone case for a google pixel 4a (not 5G). The first part is a TPU layer and then a smaller, thinner shell of PLA that is intended to protect the most likely points of impact if the phone is dropped. I also added a wooden insert I made on the back of the case. I've been using this case for several months now and find it comfortable and protective. Notes: -Use supports on both the TPU print and PLA print -There are no holes for the power button or volume control on the TPU layer because I found that they cause failure in the prints. I just cut them out with an Xacto knife post print -I placed a steel plate in the PLA layer because I wanted the case to be magnetic. There is a file for the case with and without the cutout -I also added a thin wood backing I made. To locate it there is a small outer wall on the back of the PLA layer. You will probably want to remove this or print/make an insert to go into it. -I will probably continue to update this design in the future and post new models as that happens