I did not realize that the original model was so large as it looks small in the pictures. I have split this model in to two halves so that it would print on my Elegoo Mars resin printer. I have hollowed and pre-supported both models. I have also test printed them and they printed perfectly. There is only one small issue with the top model (brain), while it is hollow I was unable to add holes to the model that would allow the trapped resin to drain so when you have finished printing you will need to drill a few holes through the bottom into the brain to drain the excess resin. I would also like to thank MagicEngineer for the fantastic model. Side note: on my Elegoo Mars each print took approximately 12 hours to complete but the detail is amazing.