A cable comb inspired by Daymo's 'NZXT Kraken Cable Comb'

I liked the look of Daymo's comb and wanted to be able to hold the 4-pin cables for my EVGA Hybrid GPU. I also made the combs longer and added a little bevel to the edges, but not enough to require any supports printing.

This was a quick design and these are very tight. Sand the notch and work it back and forth a few times before installing. Because the first version had a visible gap along the sides I made a 1mm overlap. Sanded, the pieces will fit together and slide closed, squeezing the center helps a little. Be careful not to crimp your cable while sliding them together.