ATTENTION LE FICHIER cote pi cube x2.STL EST FAUX (MAUVAISE EPAISSEUR 2mm) LE NOUVEAU EST DISPO 3MM) PICUBE for octopi pi cube pour octoprint pilotage de l imprimante (alimentation) pilotage eclairage led detecteur de filament regulation temperature pi4 et alim support hdmi pour picam raspberry sur hdd m2

detecteur filament gpio 24 et ground detecteur filament 2 fils pugin Octoprint-Filament-Reloaded-master

install relais sudo apt-get update sudo apt-get upgrade sudo apt-get install git-core git clone https://github.com/wiringpi/wiringpi cd wiringpi ./build

2 - Maintenant il va falloir éditer un fichier :

sudo nano /etc/rc.local

avant la ligne exit 0, tapez ceci :

/usr/local/bin/gpio write 0 0 /usr/local/bin/gpio mode 0 out /usr/local/bin/gpio write 2 0 /usr/local/bin/gpio mode 2 out

dans system commande editor led on gpio write 0 0 led off gpio write 0 1 imprimante on gpio write 2 0 imprimante off gpio write 2 1

ESP8266 fichier rainbow arduino

régulation température module afficheur dessoudé de la carte et placé sur le coté du cube

alimentation 5v 4A(pi4 /régulation temp/ventilateur 40mm/esp8826/LED ARGB ventilo 120mm alimentation 12v 15a led externe vis tête fraisée m3 et m4

PICUBE for octopi printer control (power supply) led lighting control filament detector temperature regulation pi4 and power supply hdmi support for picam raspberry on hdd m2

filament detector gpio 24 and ground 2-wire filament detector pugin Octoprint-Filament-Reloaded-master

install relay sudo apt-get update sudo apt-get upgrade sudo apt-get install git-core git clone https://github.com/wiringpi/wiringpi cd wiringpi ./build

2 - Now you will have to edit a file:

sudo nano /etc/rc.local

before the exit 0 line, type this:

/ usr / local / bin / gpio write 0 0 / usr / local / bin / gpio mode 0 out / usr / local / bin / gpio write 2 0 / usr / local / bin / gpio mode 2 out

in system command editor led on gpio write 0 0 led off gpio write 0 1 printer on gpio write 2 0 printer off gpio write 2 1

ESP8266 arduino rainbow file

temperature regulation display module unsoldered from the board and placed on the side of the cube

power supply 5v 4A (pi4 / temp regulation / fan 40mm / esp8826 / LED ARGB fan 120mm 12v 15a external led power supply screw m3 and m4