I made a microphone stand with spider that is cool looking and works very well :)

There is 4 options for the spider : -cut in half (easier to print) with holes for metal nail (much stronger) -cut in half (easier to print) without holes -in one piece with holes for metal nail (much stronger) -in one piece without holes

And 2 options for the mic ring : -Universal 46mm-53mm (50mm inner diameter) ( tested with the BIRD UM1) -Fifine k670 or k669 (print it at 95% scale) You can change the ring scale in your slicer to fit your mic.

You will also need : 1 x m4 screw (m4*18 or 20) with a nut and a washer. 1 x zip tie for the mic ring (or 3 or 4 small rubber bands will also work) 3 x m3 screw for plastic (or glue if you want) 5 x small size rubber band 10 x small nail if you chose spider with holes

• some glue or super glue
• a thin fabric for the pop filter
• a flat file or a dremel to flatten 2 side of the m4 screw if you want to put the screw knob

PLA or PETG plastic works very well with this build.

Some tips :

-when you put the fabric in the pop filtre you should add glue before sealing it with the inner part

-if you print the spider with holes for nail , you should add glue before inserting the nail (and cut the nail to size before putting them in)

-you can sand and add a very small amount of glue betwen the arm and the spider to get more friction

-to install the spider , follow these steps : -1- put the ring on your mic and adjust the zip tie(not too thight) -2- remove the mic from the ring and put the ring in the spider -3- add the rubber band 1 by 1 -4- put the mic in the ring