Ender control box that will fit all the electronics.

Ideas and feedback are welcome. :D

Enjoy!

Update:

04 Jan 2021: + added a frame to mount the C3D 1.1.3 board and other bords with the same layout + touch upon the design -> better printable

07 Jan 2021: + added mounting points for two additional components [30 mm x 16 mm] on the left side cover

22 Mar 2021: + widened the PSU tray + added continues rail for better customizable future parts + adjusted the angle of the LCD screen (from 115° to 111,5°) + redesigned the circuit board for the SKR 1.4 and SKR MINI E3 (C3D_v.1.1.3 ) + widened the port on the left panel for better access

Parts needed for this Project:

Parts you already have:

• 1 x LCD screen: Cerality3D LCD (recomended: BTT TFT35 v3.0)
• 1 x Motherboard: Cerality3D V1.1.3 (recomended: BTT SKR v1.4)
• 1 x Ender 3 LCD mount
• 1 x 60mm x 60mm x 15mm fan
• 1 x 40mm x 40mm x 10mm fan

Fans:

• 3 x 60mm x 60mm x 15mm fan (recomended: 1 x fan in IO shield)

Wires:

Motor/Stepper:

• 1x 4 pin X-Axis Cable Stepper Motor
• 1x 2 pin X-Axis Cable Limited Switch Endstop
• 1x 4 pin Y-Axis Cable Stepper Motor
• 1x 2 pin Y-Axis Cable Limited Switch Endstop
• 1x 4 pin Z-Axis Cable Stepper Motor
• 1x 2 pin Z-Axis Cable Limited Switch Endstop
• 1x 4 pin E-Axis Cable Stepper Motor

Bed:

• 1 x 2 pin thermistor cable
• 2 x 24V cable

Hotend:

• 1 x 2 pin thermistor cable
• 2 x 24V cable
• 1 x 2 pin hotend fan
• 1 x 2 pin part cooling fan

Screws:

• 40 x DIN965 M3 x 10
• 12 x DIN965 M3 x 20 (60mm fan)
• 4 x DIN965 M2.5 x 5 (Raspberry)
• 2 x DIN934 M4 (Ender 3 LCD mount)

Nuts:

• 60x DIN934 M3
• 2 x DIN934 M4 (Ender 3 LCD mount)