Custom electronics enclosure for a 300 x 200 D-BOT , integrated v slot mounts , Bigtreetech SKR V1.4 Turbo mounts + Raspberry Pi 3/ 3B mounting points.

Only 50mm thick so takes up the same amount of vertical height as the PSU.

Plenty of space for cable routing and management, room included for a solid state relay & 5v step down module if required.

Designed to be printed with a 0.6mm nozzle

Cooling provided by a noctua 92 mm low profile case fan ( 12v )

Lid is held on by 8 pairs of 6mm X 3 mm magnets allowing a a clean look and quick access to electronics if required .

Ideal if you are looking to upgrade to 32 bit electronics

Tested on my own machine SKR V1.4 Turbo + 2209 Drivers + Ras Pi 3B , works perfectly

Feel free to remix for your own electronics solution.

0.3 layer height 0.6mm nozzle Print Settings: 1.8mm Walls 1.20 Top 1.20 Bottom 50 % infill

approx 10 hour print for box, 4 hours for lid You need a printable area that is at least 300 X 210