This is a Popsicle Maker that i made. It comes in two versions.

A thin one, which you will need the files (1X) PopsicleMaker_Cups_STL.stl (4X) PopsicleMaker_Stick1_STL.stl' (4X) PopsicleMaker_Stick2_STL.stl

For the wide one you will need (1X) PopsicleMaker_Cups(Wide)_STL.stl (4X) PopsicleMaker_Stick1_STL.stl' (4X) PopsicleMaker_Stick2(Wide)_STL.stl

To put it together you need to only slide the Stick2 files ontop of the Stick1 files. Then you superglue them in place.

To remove the popscicles after they have frozen overnight all you need to do is put hot water into a large bowl. Then immerse the cups into the bowl for about 30 seconds. If it does not come out, then immerse it in the water again.

The Wide popscicle maker is easier to remove the popsicles when they are done.

Another thing that has made the popsicles easier to remove was to spray the inside with Polyeurothane spray. You need to let it fully cure for a couple of days before using. Polyeurothane is food safe ONLY when it has been fully cured.

I HIGHLY recommend printing these at 0.15mm layer height. otherwise the ridges on thicker layers tend to try and grab the popsicles and make them hard to remove.

you can fill the popsicle maker with any fruit juice and make healthy treats with your kids.

I printed these with 15% infill and 3 walls.