Add a little flair to your Telex headset with these cat ears!

The bottom piece has a channel 8.5mm across and 6.25mm deep for the headband to sit in. Magnets, 6mm diameter and 3mm tall in both top and bottom pieces allow the piece to add flair to the headset without permanently altering the equipment.

I have also included a top with a flat piece incase you want to try and make a different ear or something else entirely. I have ideas for devil horns and a unicorn horn myself.

The exact link I used to purchase the magnets no longer works, but these or any magnet with the same dimension should work.

https://www.amazon.com/LTKJ-Premium-Brushed-Refrigerator-Whiteboard/dp/B07RSBNJ3F/ref=sr_1_6?crid=3J9XJRRNUBZ24&dchild=1&keywords=6mm+x+3mm+magnets&qid=1603655172&sprefix=6mm+x+3mm%2Caps%2C171&sr=8-6

I have only printed these with an Elegoo Mars 2. It isn't an option in the "Print Settings" block so I didn't include that. I didn't really need to fuss too much with settings but the ears seem to get a bit heavy and the bottom pieces can deform a little. I added some extra supports and that seemed to work. These should be able to be done just fine with filament though you might need to enlarge a little depending on the accuracy of your printer.