Ergonomic watering can

-IMPORTANT: Print in SPIRAL (VASE) mode with 0.8mm nozzle and 0.2-0.4mm layer height. smaller nozzle sizes can be used but extrusion width should be 0.8 for adequate strength.

-bottom layer should be at least 4 layers of rectilinear fill pattern and make sure printer is not under-extruding to ensure water tightness. (if there are some leaks around the bottom edge seam you can fix it with some CA (super glue) along the seam on the inside.)

-Full volume is approximately 1.7 litres, useable volume 1.4-1.5 litres.