Change Note 03/08/22 - Removed excessive wiggle room for the stock spacer tubing

Change Note 03/01/21 - Updated Muzzle print, added older hop-up tab

Change Note 02/05/21 - Minor changes to Magback and Magfront. Added port labels.

Change Note 01/31/21 - Prong screw holes are smaller for tighter assembly, Elevator has shelf to prevent over-dispensing from the mags, and Magback was modified to suit updated elevator.

Change Note 11/07/20 - Frontbutt Stock Spacer Slot

Change Note 09/22/20 - Frontbutt socket fix.

Assembly Instructions: http://www.captainslug.com/nerf/R3Assembly1.pdf

Hardware Kit: https://www.etsy.com/listing/741550256/

This is essentially the inline Rival Mag system adapted from the FLAK into the Rivalburn U, but upgraded a little bit to add compatibility with the Worker 15rd Rival Mags that otherwise don't work in anything except the Hera. The foregrip actuates an elevator that presses the magazine detent, causing it to eject a Rival round onto the elevator. When the foregrip goes forward the spring return on the elevator pops the HIR up into the path of the Ramrod, and it then gets pushed into the barrel.

The top of the magwell has a hole to allow a +1 HIR to be loaded ahead of the elevator output so you can add HIRs in tandem without feeding from the magazine. This can be done whether the mag is full, empty, or even absent. Behind the +1 port is the sliding jam door port which allows you to ramrod out and then dump an uncooperative HIR.

The port in the bottom of the magwell allows the magazine to be loaded by hand when the breech is closed without having to remove it from the blaster.

The magwell accepts 15, 12, and 7 round Rival mags. Blaster is compatible with the 788, K25, and K26 springs. Adjustable hop-up at the muzzle is a 4-40 screw driven in at an angle.