I made an attempt to finish an unfinished project by JorgyTheGreat. The GameCube shell was adjusted to better fit the buttons I made because the original wouldn't allow me to power on or reset. The lid handle is meant to be super glued on top of the lid and was made using LeoDuhVinci's thumbstick. This is my first 3D printing project and I used tinkercad. Thank ya

*the gamecube.stl will alert you of "model errors" in Cura but everything is good as far as i'm aware. If anyone more knowledgable than me figures this out please let me know why in the comments.

*you need to either short the part that tells the Gamecube the lid is shut or tape the switch down as I did.

Printed on an Ender 3 V2