Spidertron Spidertron does whatever a Spidertron does

Needs only a little bit of supports you should be able to print the leg parts without supports with "engineered failure" cleaning up some of the small midair print spots

No longer needs any extra parts! tolerances are tight so please message me with your results! I printed on a Bambu A1 mini

The long legs print vertically. I included an 8x sprew version. The hole in the center is for 1.75mm filament for increased strength.

Added a smaller version that should print and assemble much easier. Doesn't require any extra hardware (other than glue) only needs supports only under the front of the legs the rest should be bridging