Modular Electronics Enclosure

###Overview This design is for a modular electronics enclosure for 3D printers. It utilizes a enclosure / tray system, which allows users to create a new tray if different electronics are needed. This configuration is setup to support an Mainboard (MKS Gen L, SKR 1.3, SKR 1.4, SKR 1.4 Turbo, & SKR Mini) , External Mosfet Board, and Raspberry Pi. All Hardware used in this design is M3.

###Revisions Initial Release - September 5, 2020

Updates to design; Lid closure fasteners from one to three, added stl files for skr mini. - October 25, 2020

###Detailed Description This design was intended to be fully customization for other users. As it features: - Simple tray system for mounting all electronics inside the housing - Simple I/O panels which can be changed - Mounting locations for the housing on two different sides - Plastic knock-out features for cable egress

The current configuration uploaded is optimized for:

MKS Gen L/SKR 1.3/SKR 1.4
External Mosfet
Rasp Pi B+

Current Hardware Needed:

6X - M3 Hex Nuts
17X - M3X10mm Screws
1X - M3X25mm Screw
2X or 3X - M6 Screws for mounting onto your printer frame

Printed BOM:

1X - Blanking Panel 1
1X - Blanking Panel 2
5X - 1mm Spacer
1X - Base
2X - Hinge Pin
1X - Electronics Chassis
1X - Lid

###Print Settings: Material: PETG or ABS Infill: 30% Layer Resolution: 0.2mm Support Needed: No

Descrição