These are a first set of alternative dungeon tiles based on openlock

1. Changes to allow routing of wires from a CR2032 battery in the base to ledson the floor and or wall
2. Modified the clip for a more secure connection
3. Offset the grid by half a square so rooms no longer have a half square taken up by walls
4. Made walls thinner (equivalent to 1ft which leaves 1ft for bookshelves/scatter before any squares are affected)

These files are all supportless because I can't stand waste when a bit of design can prevent it

It's easiest if you strip a couple of bits of wire for the battery holder and then solder the led wires to them just because there's not a lot of space and it's fiddly

to do a floor light, the led should fit on top of the battery holder and be pushed up through the hole

to do a wall light, work from the light end first:

1. solder wires to the led, thread into the light piece and glue the led in place making sure to insulate one leg so they don't short
2. thread the wires through the wall and glue the light to the top of the wall
3. thread the wires through the floor piece and glue it to the wall
4. glue the base to the floor making sure not to trap the wires
5. cut wires to length and solder to the battery holder which can then be glued under the floor

• make sure to position the battery holder so there is room to slide the battery in/out