This is a 3d printed version of the coaxium container from Star Wars Solo.

Materials needed: Magnets in the bottom optional: https://www.amazon.com/gp/product/B01E75OFG8/ref=ppx_yo_dt_b_asin_title_o04_s01?ie=UTF8&psc=1

Test tube: https://www.amazon.com/gp/product/B07W5LT92T/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1

Mesh for screen: https://www.amazon.com/gp/product/B077M93J18/ref=ppx_yo_dt_b_asin_title_o07_s01?ie=UTF8&psc=1

Lights: https://www.amazon.com/gp/product/B00LZUX07O/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1

Clear epoxy, any will do but this is what I used: https://www.amazon.com/gp/product/B0823LC5H1/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1

Rub and Buff: https://www.amazon.com/Buff-Bundle-Silver-Leaf-Gold/dp/B01N35SMT2/ref=sr_1_5?dchild=1&keywords=rub+and+buff&qid=1598818956&sr=8-5

Instructions:

3D print all parts. I recommend using a resin printer with blue/white mixed for the star. Sand all parts and paint. I used rub and buff silver and gold.

Mix the two stage epoxy carefully. The gentler you are the less air bubbles will happen. Fill the test tube with the clear epoxy. Put the star in the test tube and let sink to the wanted depth. Either continuously spin the test tube or set on its side so the star won't sink any farther. Let cure for several days to ensure completely cured. [img]https://i.imgur.com/AAfqSQW.jpg[/img]

Assemble the canister: Cut the mesh into a strip. [img]https://i.imgur.com/iDEKTYf.jpg[/img]

Place in canister top: [img]https://i.imgur.com/BSU0fc7.jpg[/img]

Slide on canister: [img]https://i.imgur.com/EIjgK1A.jpg[/img]

Assemble the tube: Bottom: I put a magnet in the bottom. I believe this is optional after having it together. Adds weight. [img]https://i.imgur.com/5gE2kDy.jpg[/img]

Glue the bottom bottom and bottom top together: [img]https://i.imgur.com/QGCgLvY.jpg[/img]

Top: Cut the loop off the light: [img]https://i.imgur.com/fLNnwMd.jpg[/img]

Disassemble the light, careful not to lose the clear plastic: [img]https://i.imgur.com/v10dXI8.jpg[/img]

Glue to top bottom and the light so the threading shows out the top: [img]https://i.imgur.com/1jtuvHM.jpg[/img]

Glue the cap and the top top together: [img]https://i.imgur.com/wZtbC3b.jpg[/img] [img]https://i.imgur.com/nqTI3OF.jpg[/img]

Glue the bottom and top to the tube: [img]https://i.imgur.com/Gnd4wX7.jpg[/img]