RIBBON CABLE MAY BE TOO SHORT TO BE USEABLE

Very Close to Y-AXIS

This is a screen mount I designed for the Ender-3 V2. I wanted to be able to adjust the angle of the screen to be seen more directly to where I work from. Unfortunately, the cable for the screen is too short to be able get to vertical. The mount can be mounted on the left side, and the cable can be run to it.

Future mods to occur. Flip left out of the way for bed leveling.

When loading in CURA, the part needs to be flipped 180˚ so the hinge is high on the Z axis as opposed to on the bed. No supports are needed, but a BRIM should be used