Smartphone holder for use with magnifier app. Mountable at table with board thickness from 10mm to 35mm. Smartphone distance from board adjustable between 90mm and 134mm. Fits for smartphones from 62mm to 95mm width. For thin smartphones some rubber pads within the holder might be necessary.

Printing of screws:

• wall thickness 3mm minimum
• no support

Printing of other parts

• wall thickness of 1.5mm minimum recommended
• support needed
• no support may be required for the slot.

Slider of smartphone holder might be printed in vertical position with less support. But then it doesnt slide well in the holder.

All clearances are 0.2mm. 0.4mm within the thread.

If printer creates an elephant foot (Ender 3 problem), the use of a file after printing might be necessary to get the sliders sliding.