You're on 3DFinder
We search Thingiverse, MakerWorld, and Printables at once so you get the best of each.
Description
We had a lamp post with the lid off. So I printed this key, after fixing it, to put in place again.
It's not a constant width polygon, so the sides didn't match. So I sketched over a reference photo with 2 arcs with FreeCad.
It perfectly fitted on first try. I have given 0,2 mm of extra margin on top of the height of the triangle. It's a modificable constraint of the sketch.
Prints fine without supports.
Dirt inside from using it in first photo.
4
Likes
0
Downloads
8
Collections
Tags
key
lamp post
service tools
License
Creative Commons - Attribution - Share Alike
Like this model? Create a free account to save your favorites and come back to them later.
Create account