I saw other racks like this and wanted to print one for myself. It turns out I have a tiny printer so I had to redesign everything to work with my specific equipment and print bed restrictions. Unless you have this exact same setup, you'll probably be in the same boat.

As long as I was doing it, I made the sections fit together with dovetails so everything would be rigid.

I used monoprice cat6 keystones for the patch panel but my guess is most of these are the same. If you assemble the faces then install the keystones, everything will lock together.

I included the male and female dovetails if you want to build a section for your equipment.

I included a photo of all the misprints from measuring mistakes because this was stupid and took forever.