This is a Case for the gherkin (Bluetooth + QI charger) keyboard.

It only has one hole in the bottom for a physical switch.

I got a warning that the print was too large for my Ender 3 but it was fine to print one by one horizontally in the supplied orientation.

I used Wood PLA so the resolution was 0.5 resolution, if you using PLA maybe set to 0.4?

No need for support.

The top plate is deliberately tight; you need to sand off the inner walls a bit and it should snap into the bottom case snug.

This case is compatible with both the "double-pcb gherkin" or the gherkin using the top-plate for the switches.

You can add a sponge or sorbothane sheet between the pcb and casing to optimize sound and reduce shake :)