Our family often wanted to show videos at our dining room table, but found that most tablet stands were too low for comfortable viewing if anything was on the table. This stand elevates the tablet while also leaving room for a bluetooth speaker underneath. It is very sturdy when all pieces are printed flat. The width is adjustable.

Print 2 sides, 1 rail, and 4 clips. No supports necessary for any part.

As printer tolerances may vary, a small test rail is included. Print this before the main rail. If it is too large for the slot in the sides scale it down in your slicer by a few percent and try again. When you find something that works, scale the rail down by the same amount.