PLEASE READ: I loved the design Coumbaya's case for the Corne, and I wanted to adapt it for my lily58 board. I am not a CAD expert (I used TinkerCAD) to create this case. This is a PROTOTYPE I made and so is specific to my build. I only put it up out of popular demand and to help out the awesome keeb community :)

Some things that I accounted for in this build:

1. Accounts for foam. I used some foam from my Ender3 packaging that is a little less than a quarter inch thick.
2. No screw holes. My pcb rests on the foam itself, I found it gives a 10x better sound than if it were screwed into the case.
3. I took off the bottom of my sandwich case, had to trim the header pins of the arduino too to get a relatively flat pcb bottom.

I would love to add screw holes, make the right side port smaller, add cutout for underglow LEDs, etc. But I do not currently have the time to figure out how to do so. If you have any modeling skills better than mine, please feel free to remix this!! I would love to reprint any better models you create. <3