This is my design of a D&D PDT. I originally printed off the design by Takly (I'm sure you can see the similarities) because I really enjoyed the concept. I felt that it didn't fit together the way I wanted it to. So I took some rough measurements and set off creating my own. I took it down to two parts, the base, and the door. I have printed a few two-tone towers for different characters. It does not need any supports or rafts. On my ender 3 with .2mm layer height and 10% infill, the base took 5 h 41 m and the door only 2 h and 3 m. It does not use a lot of plastic either. As I use it in some upcoming sessions I will revise any issues I run into. I'm hoping the door stays tight, but if it starts to loosen up I will look into fixing it. The only flaw I have found is if you shake it too hard the dice will knock the door open. The door is attached and removed fairly easy, so you can swap out colors as needed. If you have any thoughts on improvements let me know. I have already considered trying to add a magnet latch to the door. Thank you, and may you always roll a 20!