Head Banger

Banging your head against a brick wall?

Now you can without the pain!

Or just Head Bang!

Instructions:

Print 2 brick walls and glue on top of each other
Glue main body onto base raised tabs
Glue triangles onto base snug against bases raised tabs
Glue brick wall onto base. Put glue onto backs of triangles and base edge
Glue Head onto platform. Make sure back of neck is even with back of platform. Also make sure the platform is facing in the correct direction.
Put glue into the holes on the sides of the platform and insert pins to hold platform onto upper base
Insert large dowel into lower base holes. Do not glue
Cut the bottom disk off the 3rd pin
Glue 3rd pin into hold on large disc
Glue disc onto large dowel making sure dowel is flush with the disc
Insert smaller disc onto large dowel on the opposite side. Do not glue
Insert handle onto large dowel snug against small disc and glue into place
Insert rectangle shaft onto both the platforms square pin and the large disc’s pin
Glue the square pin to the rectangular shaft. Do not glue the lower pin on shaft
Glue the optional “Bang!” onto the brick wall. Make sure that the top of the Bang is no lower than 2 rows down from top of brick wall.
Crank it and do some head banging!