Steampunk goggles V2!
The radialengine_10gear-all.stl is designed to print as a single piece. I am going to upload a nosepiece at some point that should fit snugly between the outer ring and the goggle body.
18 August: A new file, radialengine_12gear.STL, has been uploaded. It prints a heck of a lot nicer, and the shield is much nicer as well. I highly recommend using this file insteasd of the 10gear version

Print it, paint it, wear with nerdpride.
Use 52mm colored photography filters (they should fit quite nicely) for a nice look!
18 August: There is some after-print finishing work that needs doing. The slots for the strap need cleaning (some of the bottom noodles have trouble adhering in the proper spot if you don't print with supports, which I try not to do). The double nose-piece might also need some trimming as arcs are hard to print without underlying support. I didn't use supports and had little trouble with it.