I initially used Harpalyke's mount, but was advised by E3D support not to put anything between the fan and the heatsink (They said it could affect air pressure), so I came up with this design that instead attaches to the outside of the fan

Three mounting options:

1. Use longer versions of the screws attaching the normal Hemera fan
2. Use the two unused screw holes to bolt the mount to the fan but not to the heatsink EITHER Find suitable screws that will screw into the plastic of the fan (They need to be quite long) OR (Recommended) Superglue an M3 nut into each of the holes in the fan and use M3 screws
3. No screws at all - it's quite the snug fit

Also features a zip tie mount on the bottom to secure thermistor / heating element wires Has cutout at top for fan power wire

Offsets: X -31, Y -35, Z -2.75

Not compatible with HangTight's part cooling fan shroud, I use permanoob's

REMIXING ======== Original Fusion360 model: https://a360.co/2xow3nV To change the height of the BLTouch mount YOU DO NOT NEED TO KNOW HOW TO MODEL IN FUSION360!

1. Open the file using the free version of Fusion360
2. At the top Modify > Change Parameters
3. In the table that pops up, change the value of BLTouchZOffset (eg to raise it by 5mm, enter 5, to lower it by 5mm, enter -5)
4. Click OK
5. If you DO NOT want to include the Zip tie mount: In the tree on the left, Expand "Bodies", Right click "BLTouch Mount" > Save As Mesh
6. If you DO want to include the Zip tie mount: In the tree on the left, right click the root object ("Hemera BLTouch Fan Mount") > Save As Mesh
7. Save as STL or 3MF