A tiny version of the 'MechanicalEggHolder' for tiny eggs..

Original model: https://www.thingiverse.com/thing:4272321

All parts of the model can be printed without support material, but infill is needed.

Tip: Make sure to wait with removing the Base, Turning Plate and Outer Gear part from the heating bed until the bed is completely cooled down to avoid any deformations. This way these prints stay nice and flat:)

If the center gear is too lose: use (super) glue to attach it to the Base part (don't forget to place the Ring and Turning Plate first). If the connection is too tight: I recommend removing some material of the center axis of the Base part for example with sandpaper.

Enjoy!:)

Check out my Instagram for more 3D printing projects! @digitang3d