An easy to print switch with XT60 connectors that is usefull for anything powered byXT60 batteries:

• FPV groundstations
• Soldering irons
• Test equipment
• Etc.

Parts needed:

1 x XT60 Male Connector 1 x XT60 Female Connector 1 x Switch (21X15MM On/Off SPST 2 pin rocker switch 1 x Wire 15cm 4 x screws (2.2 - 2.5mm * 12mm)

I used Female from an old battery which if cut to the correct length helps hold the XT60 in place even without glue.

NOTE: XT60 sizes vary a little. You may need to use some epoxy resin glue to hold xt60 firmly in place.

Also included are google sketchup files for modifications