Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Fully articulated T800 arm. Most of the hand is taken directlly from OneldMONstr's model, except the hand and the finger/thumb pistons they are from nracmo. There are 3 holes for 4mm screws, 2 on the elbow and one on upperarm1b, they are to lock the joints in place. i used 3mm screws to attach the fingers to the hand. I used 3/8" plastic tubing for all the piston rods on both upper and lower arm. I used filament glued in place to act as screws on the wheels in the fingers and on the lateralFingerPistons. Filament was also used as piston rods on the finger and thumb pistons. I used a heatgun (on low!) to soften the armTube to pop the wrist in place, and again on the armRodTips to form them securely around their joints. Be careful with the heatgun, too much heat too fast can ruin your part. UpperArm1a and 1b were glued together. I left the finger pistons out of the complete model and meshmixer file to keep the files sizes down.
