EASY face shield designed for printers will smaller build plate. Leaves room for glasses or masks and clear plastic can be attached using a standard 3 hole punch.

Instructable can be seen here: https://www.instructables.com/id/The-Easy-Face-Shield/

Assembly video here: https://youtu.be/gym9bxymmWo

Stackable v3 video here: https://youtu.be/9DczuSu2s0c

Updates for Version 2:

• More forehead room for glasses and larger respirators
• rubber band hooks have been redesigned, one is now a hole for a loop and the other is a larger hook so the band cannot fall off and it is easier to wear
• "nubs" to hold plastic sheeting have been reduced in size by 0.015" with additional fillets to make it easier for installation of plastic sheets, especially for thicker sheet stock

Updates for Version 3:

• nubs are now centered on shield and supported with ribs
• holes on forehead rest have been removed
• changes to allow stacking during print
• stacks are separated by 0.013"
• ENABLE RETRACTION BETWEEN LAYER CHANGE DURING SLICE

Updates for Version 4:

• four additional sizes added, XS, S, L, and XL
• shield size from v1-3 labeled as M
• sizes shown on right side frame
• forehead rest smoothed for padding
• see included size chart PDF

Overall build size will fit on a 150mm x 150mm bed for versions 1-3 and size M for v4