This is replacement button for E-MU Emax synth VOLUME/DATA slider. I tried to imitate as much as possible the original (on photos, black is the original, greyish is the printed part).

Should work also on Emax II and any slider with the same slider width (4 mm).

As a small part, there are two versions : original and original with 1 mm added to the inner slider width, if there were troubles fitting the button.

You should print this in black at 50 µm (30 minutes printing) for the best results.

IMPORTANT :

• You might need to use a scalpel to clean the inner hole to fit perfectly.
• NEVER force on the slider to put the button.

The models have to be repaired first in Repetier before printing.