This is a wall mounted lamp for LED bulbs only.

You have to buy a lamp socket for E27 (max 7 W) bulbs as shown in the pictures. In addition you need wires to connect to a wall outlet.

Print upper and lower lampshade with

• white PLA
• 0.2mm Quality
• 100% infill
• 5% support
• brim

Remove support of upper and lower lampshade with care as to keep the three "foots" intact

Print ring with

• 0.2mm Quality
• 20% infill
• 5% support
• no plate adhesion

Remove support of

• lower wells (3)
• lower foot holes (3)
• wall mount cavity on backside of wall plate
• screw-holes in wall plate
• inner hole of ring leading from wall plate to inside of ring

DANGER: Do not do any electrical wiring if you have no sufficient experience!

To connect the lamp to the wall outlet have to pull the wires through the hole in the wall plate to the inner side of the ring as shown in the picture

Assemble the lamp by inserting upper lampshade with 3 foots of the upper shade going through the 3 holes of the ring, Check that the lampshade is fittet into the well of the lamp ring, then turn right. Do the same with the lower lampshade