This is a clip to attach a cane (22-23mm shaft) to a small medical walker to allow the cane to be attached to the walker when not needed but to still be available while walking. Because the cane is at a right angle to the support pipe the 3D print could not be a clip on to both the frame and the cane as one or the other would have the layers running across the clip and would not be strong enough to flex and spring back. The solution I devised was to make the cane holder a clip and the pipe mount a moulded fitting with tie strap access holes built in. This also allows the print to be positively positioned with the canes clip held vertically to keep the cane in the desired position.