Here is some accessories for the Foldable Camera Tripod Remix.

The cell phone mount attachment is a remix from Quadhands Helping Hands Cellphone Mount Attachment by nobble. I liked the simplicity of the design and the use of a rubber band is simply brilliant! But the original design had the rubber band in front of the screen and I didn't like it. Also the original was made for a thinner phone and it didn't fit mine. So I made it for two thickness: 12 and 16mm. The pictures shows a Samsung Galaxy A50 and Galaxy S7 in a OtterBox case.

You will need:

• one ¼-20 x 1½" hex or carriage bolt (pick the right thumb bolt)
• one M4x20 + two M4 nuts for the swivel part
• two M2.5x10 + two M2.5 nuts to attach the clip to the swivel#

You may if you want glue the swivel part to the clip part. Use a piece of filament as a guide pin.

Printing tips:

• Print the cell phone mount attachment with support touching build plate only.
• Print the thumb nuts and swivel parts as shown in the picture.
• In CURA set the "Top/Bottom" and "Bottom Pattern Initial Layer" to "Concentric" when printing the thumb nuts for a better look.