I edited CongoJoe's stacking pi case in the following ways:

• Increased size of some input holes
• Embedded images into svg file
• Changed size of side clip holes
• Added Pumping Station: One logo

This Raspberry pi case is for use with the Raspberry pi.

This stacking pi case fits really nice together in 3mm wood. I would recommend wood for keeping your pi near-permanently inside. Taking it out constantly will wear down the clips.

This design also works with 3mm acrylic. It doesn't fit as tightly together, but can easily be taken apart.

This design comes with two top plates, one half and one full.

The following images are from the noun project: thenounproject.com/noun/ethernet/#icon-No456 thenounproject.com/noun/power/#icon-No94 thenounproject.com/noun/usb/#icon-No140 thenounproject.com/noun/sd-card/#icon-No3584 thenounproject.com/noun/computer/#icon-No115 thenounproject.com/noun/speaker/#icon-No1898 thenounproject.com/noun/television/#icon-No416

The Raspberry Pi logo is from the Raspberry Pi Foundation and Raspberry Pi is a trademark of the Raspberry Pi Foundation. http://www.raspberrypi.org/

The Pumping Station: One logo is from the Pumping Station: One hackerspace. http://pumpingstationone.org/