Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Vented enclosure for 3cm x 7cm PCB prototype board. I'm using boards from (this kit.
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
1
Curtidas
0
Downloads
6
Coleções
Tags
case
electronics
electronics enclosure
pcb
prototype
Licença
Creative Commons - Attribution - Non-Commercial - Share Alike
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta