My 2nd try on a vase design!

• Original Z-size: 150 mm (scaled to 180 mm without any problem)
• Size of prototype: 120 mm

Printer settings on Prusa i3 MK3S (slicing done with PrusaSlicer 2.1):

• remove top layer and infill!
• Layer height: 0.25 mm (also 1st layer) - use quality filament!!
• Vertical shells: 2
• Horizontal shells: bottom = 4 | top = 0
• Infill: 0 %
• Support material: necessary only for the half where the bevel dovetail goes inside the vase
• Temp settings: first layer = 205° | second layer = 200°
• Watertight = NO (use liquid rubber spray like "Plasti Dip" to make it watertight after the print).

Filaments used - all PLA (see pictures):

• Fillamentum "Extrafill Crystal Clear Iceland Blue"
• Eryone Transparent
• Prusament "Vanilla white" (Prototype)
• OWL Filaments "Petrol" (Prototype)