a LED light for indoor/outdoor use.
Ideal to take on a camping trip to light up the tent.

Requirements:

1 x 3D printed LED light
1 x 2 AA-battery holder (or any other sufficient 3v supply that fits)
2 x AA battery
6 x bright LED
1 x toggle switch
wiring
soldering iron
hotglue

Instructions:

• print the LED light
• insert toggle switch and LED's
• solder cable between the LED pins (long ones to long ones, short ones to short ones)
• solder battery holder + to middle pin of the toggle switch
• solder long leads wire from LED's to any other pin on the toggle switch
• solder ground from battery holder to ground of LED's
• position battery holder with hotglue
• test
• if successful : hotglue LED's in place, and cover wires.

Tips:

• on the back there are 2 holes for hanging your lamp onto something, either use some wire or use cable ties to hang your light to someting.
• even on cheap batteries, the lights last for quite some time (mine lasted for over 24 hours)
• all parts can be found on dx.com for a few bucks