Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
This is a case for an RFM69CW BMP280 remote. It's part of a larger project. For more details see Hiking Data Logger on instructables.com.
-
BMP280 Base.stl - 20% fill, High resolution, no support
-
BMP280 Cover.stl - 20% fill, High resolution, no support
-
BMP280 Base+DC.stl - 20% fill, High resolution, no support
BMP280 Base+DC adds a hole for placing a power jack for charging the battery. See www.aliexpress.com/item/32919971020.html for the plug, connector and rubber seal.
I wrapped a very common lipo charger using: BMP Charger Base.stl BMP Charger Cover.stl
The lipo charger is www.aliexpress.com/item/4000522397541.html For the small lipo battery you need to replace the resistor R3 with a 3.3K to reduce the charge current. This will also allow you to plug it into any USB port without the port complaining about it drawing too much current.
I used 2mm acrylic rod as wave guides for the LEDs on the charger. The rods are cut, polished and epoxied into the two holes on the charger cover.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta