Conduit Pipe Camera Tripod (Extendable)

The Tripod is built using only PVC conduit piping and some 5mm bolts and nuts.

Print the following parts as indicated:

Parts to purchase:

3 x 25 mm conduit piping (Length should be between 600 - 1200mm) estimated $1 - $3
3 x 20 mm conduit piping (Length should be 10mm longer then your 25mm pipes) estimated $1 - $3
3 x 20mm round rubber feet covers estimated $1 - 3

Bolts and Nuts:

Step 1:

Drill one 5mm hole center straight through,10mm from the top side of each 25mm conduit pipes.

Step 2:

Insert all 3 25mm pipes through the Tripod Head V3 and attach them using the 40mm bolts.

Step 3 :

Step 4:

Insert a 20mm bolt thread first into each of the Tighteners, and the 60mm into the remaining one.

Step 5:

Install the Camera Mount Hex on top of the Tripod Head V2 using a 5mm nut and the 60mm Tightener.

Step 6:

Glue in place each of the 20mm Stopper Caps on to one side of each of the 20mm conduit pipes.

Step 7:

Place a Leg Extension Hex through each 20mm conduit pipe with the 25mm opening facing the 20mm Stopper Caps.

Step 8:

Insert the 20mm conduit pipes into the 25mm conduit pipes and glue the Leg Extension Hex to the 25mm conduit pipe with the screw holes facing outwards.

Step 9:

Insert a hex nut into each of the Leg Extension Hexes and tighten them lightly using the 20mm Tighteners.

Step:10

Glue a Foot V3 to the bottom of each of the 20mm conduit pipes, and place a Rubber end cap over each of the round bottoms.

DONE!!

I suggest you also use this phone mount should you want to mount a phone: https://www.thingiverse.com/thing:1460181

I will post a more reliable phone mount at a later time.

Please feel free to record yourself doing these steps to help improve this guide. You can contact me on 1997corry@gmail.com